Monthly Archives: October 2018

Choosing A Sink For Your Master Bathroom

A plumber in Philadelphia can help you with your problems with your Philadelphia house. Plumbing problems usually seem to happen at the wrong time. At some point, however, most homeowners will need to hire a plumber. Choosing plumbers can make the difference between a good experience and a terrible one so it is vital that you be selective when picking a plumber. A significant component when selecting a plumber is, you’ll find usually a couple of different types of plumbers: those that do repair work and those that specialize in new construction and remodeling projects.

Use a brush-on primer to prepare both ends of the connection. Follow up with the adhesive, then insert and twist the pipe a quarter turn. Hold the pipe in place for about 20 seconds to allow the adhesive to set.

Purchase a comparable anode rod at your local hardware store, home center or Plumbing house. If a bendable rod is available, consider purchasing it to make installation easier if you have little headroom to work with. Remember, the old rod will probably be only a fragment of its original length and won’t give you a true idea of the room you need to install its replacement. Before installing the new anode rod, wrap the threads with Teflon tape to create a better seal. Make a note of when you made the replacement on or near the water heater (my wife recently asked me when the I replaced the air filter on our furnace – I said it was just a few weeks ago – actually it was seven weeks earlier – time does have a habit of getting away from us).

If you purchase a wood-burning stove, make sure it has an Environmental Protection Agency certification. New models are certified, but older models need to be tested. Carbon monoxide is a big concern when it comes to burning wood inside of the house, so be sure to check your stove for leaks.

In the event you cannot get a tight joint when installing new pipes, it is probably because you did not cut it cleanly. Buy the proper tools for the job like a pro-level tubing cutter, saw blades, and a pipe saw for plastic pipes. This may ensure that your cuts are clean and perfectly measured.

If you are seeing areas in your ceiling or walls that appear to have water damage or are sagging, make sure you turn off the power before inspecting. Electricity and water do not mix. The last thing you need is to go into the attic and get shocked by a pool of water.

Tip: Install a tee on the pipe before it transitions to a horizontal run. Have the leg of the tee pointing down. Cap off the end or put a full flow ball valve on the end of the nipple. It will serve a couple of purposes. First, it will help trap debris in the line before it jams your air tools. Second, it will act as a water drain.

Who are you going to choose once your mechanical systems fail? Do you rather contact a stranger or the local, reliable family plumber? Wow! Imagine that, a local, trusted family plumber. Such a concept! Imagine this. You’re driving to work or better yet, you are heading out of town on a romantic weekend get-away. All things are running smoothly when suddenly your cell phone rings. The kids are calling with worry in their voices. Water is gushing! Sewage is oozing!